Dune Wave Vase

A sculptural vase with flowing sand-dune waves. Designed in Osaka, printed to order here in the UAE.

AED 110

PETG · made to hold water

See the waves

Sun position

Low light rakes across the wall, and every ridge throws a shadow, like wind ripples on a dune at sunset.

Colour: Sand

Material: PETG, one colour
True size: 12.8 × 12.8 × 24 cm (W × D × H)Neck about 7 cm across inside; holds about 2 litres
Weight: 171 g Sliced
Print time: About 4 h 43 min Sliced
How we know: Sliced in OrcaSlicer 2.4.2 for a Bambu Lab P1S (0.4 mm nozzle) with Generic PETG and our standard settings: 0.2 mm layers, 15% infill.

Will it hold water?

It’s made for fresh flowers. The wall is 1.7 mm of solid PETG (four printed lines side by side) on a solid 2 mm floor, not the single thin line of a “vase mode” print, which often weeps at the seams.

Before we promise it on the shop page, the first test print gets a 24-hour water test.

How it’s made

The waves are part of the wall itself: the inside follows the outside, so the wall stays the same thickness all the way round.
It prints standing up with no supports. No ripple is steeper than 42°, so every ridge builds on the layer below.